HIGH VOLTAGE SCR CONTROLLED POWER SUPPLY, 0 – 2800 VDC, 45 AMPS, P/N 18574PS
Customer requirement is as shown:
- High Voltage SCR Controlled Power Supply, P/N 18574PS
- Input: 480 VAC, 3 PH, 60 Hz,
- Output: 0 to 2800 VDC, 45 Amps
- SCR controlled
- Power section enclosed in a floor mount enclosure
- Control section is attached to the power enclosure as shown.
- Manual / PLC switch is provided to switch between Manual mode and PLC mode.
- Voltage control and current limit are provided with manual potentiometers.
- Voltage control and current limit can be adjusted in the 4/20 mA format.
- Output filter is not included.
- Ripple degrade as output is lowered.
- Voltmeter and Ammeter are provided to monitor output.
- START / STOP push button capability provided in the manual mode.
- START / STOP push button capability provided in the remote mode.
- E-Stop provided for emergency power shut off.
- Power on light
- Over temperature protection provided on the rectifier power module.
- With the Remote START / STOP and 4/20 mA interface, the unit is ideal for automatic operation.
The photo of the entire unit is shown below:
Scr Power Supply, 0 – 2800 VDC, 45 Amps, P/N 18574PS
The system block diagram is shown below:
Block Diagram
The SCR controller and the Rectifier Power Module are shown below:
The High Voltage Rectifier Bridge (2800 VDC, 45 Amps) is shown below:
High Voltage Rectifier Bridge provides 2800 VDC, 45 Amps
The lay out of the unit is shown below:
Component layout inside of the enclosure
To discuss your specific requirements, please contact us toll free at (800) 595-7096, or send us an email at [email protected].
